DiPlay
English

Connect in order

0.2.22 — USB voice messages, Voice Memos and dictation use smaller microphone packets; vehicle confirmation is pending. Reconnect retries when the USB network opens; late wired startup can wait up to 45 s. This is a recovery limit, not a guaranteed connection time.

  1. Use the vehicle’s documented USB data port and a known data-capable cable. Unlock the iPhone.
  2. Open DiPlay and select Connect with USB. Approve USB access on Android and Trust/CarPlay prompts on the phone.
  3. Approve the local VPN permission if shown. It carries the USB network connection locally, not a remote internet VPN service.
  4. Keep other projection apps closed and start with H.264 / 30 fps / Default scale.

Phone-specific evidence

Seal 06 report #57 says iPhone XS Max / iOS 18.7.1 connects on 0.2.7, while iPhone 13 Pro / reported iOS 26 reconnects repeatedly on the same car. That is a report for those combinations, not all iOS 26 phones.

Han / DiLink 4 report #11 describes working wired projection and touch, but repeated permission prompts and a 15–25 second startup. A head unit can permit a working link while retaining firmware-specific permission behavior.

If it still fails

Save a diagnostic report after the failed attempt. Record whether the iPhone is discovered, permissions are accepted, the UI loops before projection, or audio/video starts then stops.

Do not infer an ADB requirement from a USB failure. Core CarPlay has no runtime ADB requirement.

USB handles bounded USBMUX control-reply padding and permits unfinished Manual hotspot settings for wired sessions (PR #114/#130). The USB correction targets captured iOS 27 framing. End-to-end wired media and reconnects on the non-BYD device in #100 still need confirmation.

#122 reports repeated access/pairing prompts without a CarPlay connection. Its exact DiPlay, firmware and iOS versions are incomplete; the report establishes neither a universal cause nor a fixed release. Keep that symptom separate from USBMUX framing failures and record the exact versions and diagnostics.

USB disconnects or shows no permission prompt?

Use a data port and short data cable, unlock iPhone and accept the actual USB/CarPlay/local VPN prompts. If charging or permissions restart, try Reduced/Low charging when available and reconnect. Idle read timeouts alone are normal; 0.2.18 fixes specific errors including USBMUX cancellation failure.

Separate USB detection from playback

USB startup avoids repeated two-second waits and requests CarPlay mode first on iOS 26. Auto-confirm recognizes the system USB dialog; on Android 7.1–9 with no permission page, already-approved network ADB can grant USB access. Vehicle acceptance remains pending.

  1. Check that the phone is detected with a known data cable and the car’s USB data port. Charging alone does not prove that the data connection works.
  2. Unlock the iPhone and accept the prompts actually shown on the phone and head unit. Note whether the USB, CarPlay or local VPN permission prompt never appears or returns repeatedly.
  3. If playback starts and then drops, note whether charging or permission prompts also restart. Compare one cable or charging setting at a time and save a diagnostic report after reproducing the failure.

Version notes for this guide

0.2.17 — If USB drops every few seconds, try Settings → Connection → USB connection → iPhone charging → Reduced (1.5 A), then Low (0.5 A), and reconnect. Normal remains 2.4 A. This changes the offer to the iPhone, not the port's physical limit; suspected Qin PLUS DM-i power insufficiency is unmeasured. Vehicle acceptance is pending.

Full updates, older version details and their validation limits are now collected in the version history. Follow the links below for the complete notes.

Reported setups

The following are source reports, not a universal affected-car list. Unknown fields remain unknown.

BYD Seal 06 DM-i · DiLink 5 · Android ?

iPhone 13 Pro / iOS 26 · DiPlay 0.2.7
Reported incompatible

Reporter describes repeated USB reconnection with this phone. Issue closed; no confirmed 0.2.8 retest. Year supplied in a reporter comment.

View original report
Last verified: 2026-10-01
BYD Seal 06 DM-i · DiLink 5 · Android ?

iPhone XS Max / iOS 18.7.1 · DiPlay 0.2.7
Limited evidence

Same reporter says this phone connects over USB. Audio, controls and long-term stability not assessed.

View original report
Last verified: 2026-10-01
BYD Han · DiLink 4.0 · Android ?

iPhone 13 Pro Max / iOS 27.0 · DiPlay 0.2.0
Works with known issues

Projection and touch explicitly work. Steering-wheel media keys fail; USB permission repeats and startup takes about 15–25 seconds. Newer steering-wheel implementation exists, but this exact setup has no retest.

View original report
Last verified: 2026-10-01

Related GitHub issues

Closed does not necessarily mean fixed. The source is authoritative for later updates.

Your next step

Sources

View source details (4)